Dell Inspiron 3650 Powers on Fans Run Then Shuts Off and Powers Back on Again

  • We hope all of you have a capital holiday season and an incredible Parvenu Year. Thanks so much for existence division of the community!
Jan 29, 2014
6
0
10,510
0
  • #1
Hello, I've been having some perturb with my almost 5 year old background, an inspiron 545 (miniskirt towboa version).

In essence about 3 weeks agone it started attractive a while to turn on, or would only turn on all now and and then. No big mint, I figured, I mostly just use it for casual play anyways and I've got my laptop. Roughly a week subsequently that, it beautiful much wouldn't turn on the least bit.
I did a trifle reading suggesting to pull out the power line, harbor the power clit, and re-plug. This worked for about another week, though by the end of it I had to wait about 20 mins later doing that for it to power happening. Soon after it rightful wouldn't turn on at all.
I did some more googling and found stuff regarding the cmos, pulled it out, and though the power button would loud brownish-yellow when pressed, if you held it it would keep flashing connected its on for a few minutes then the pc would start. In the manual it says that this is a subscribe that there's a component that ISN't installed far-right. I had upgraded the disk drive and video card, then I tried information technology with the stock ones instead and information technology made no difference. I tried cleaning the Random-access memory as suggested in the manual, no difference.
Aft a while of fussing around, the pc just wouldn't turn happening at all, none matter what I tested. I googled around and this sort of thing measured like a PSU problem. And so I replaced the 300w PSU with a 450w PSU with similar amperages. This does seem to have helped, as the personal computer will start if the cmos is removed, but the way it starts is a less messed up. I still have to have the CMOS removed, hold the power button, time lag for the flashing, and then eventually it starts up. I'm about to supercede the CMOS battery too to construe if information technology makes a difference, simply does anyone know what is going on? Is my mobo dying or something?

ko888
Feb 18, 2009
16,676
27
84,990
3,101
  • #2
Are any of the conventional electrolytic capacitors on the motherboard bulging or leaking electrolyte?
Jan 29, 2014
6
0
10,510
0
  • #3
Okay, so on that point's zero dead giveaway like leaking capacitors.

Replacement the CMOS doesn't look to have done anything. I also ran a memory mental testing and all my memory is detected and at that place's no errors patently. I'm going to try updating the bios and see if it's an issue thereupon. To eliminate a variable I've also started it without the disk drive and HDD, but the same process is required. So I know it's not the PSU, the GPU is also jolly recent, it's not the RAM, it's not the drives, it's not the cmos, and I've besides tried other power parallel bars, superpowe cables &ere; outlets. There's nary international hardware that should be intense slews of power so it can't be that either.

As wel the room I have to set off it up has changed a bit - I suffer to displume out the cmos, unplug the system, hold the power button, replug the organisation, the power light flashes 4-5 times, then it starts on its possess with no Post beep. Once this is through in that respect's obviously a cmos error on startup, but information technology can run for hours regardless of application, I can do photoshop or play skyrim or watch an HD movie, it all whole works fine til I squinting information technology down.

However given this thread: http://nut.community.dell.com/patronise-forums/desktop/f/3514/t/19440584.aspx I'm going to strain and tryout my memory 1 control stick at one time, and with better stuff that windows' on board matter. However I'll start with the dell designation thing just just in case, I figure it probably checks out the mobo operating theater CPU leastways in some way, which would at least give Pine Tree State some peace of mind. I really don't want to be stuck with those dead.

Jan 29, 2014
6
0
10,510
0
  • #4
Could really use someone pointing me in the right direction. I've run 3 different memory checks (windows, memtest86, dingle), whol of them came improving dead clear, the diagnostics utility from dingle says the cpu and mobo are fine every bit well. I tried examination every several stick of memory 1 at one time, and the pc wish not start with any unary one as elongate as the cmos is in there. Should I assume my cram is in "safe mode" like that link suggested and is functioning simply has undetected problems, Oregon maybe the PSU I had before really did miscarry and took something with it on the mobo to do with ram and now I've got this issue, operating theater is it somehow the CPU?

I really get into't have a go at it what to do anymore.

ko888
Feb 18, 2009
16,676
27
84,990
3,101
  • #5
Borrow and troubleshoot victimisation a better quality power provision unit.

Sometimes you may face-off a new PSU that isn't in full compatible with the OEM motherboard.

Jan 29, 2014
6
0
10,510
0
Jan 29, 2014
6
0
10,510
0
  • #7
A different PSU doesn't seem to relieve oneself a difference.
ko888
Feb 18, 2009
16,676
27
84,990
3,101
  • #8
The only thing left would be to render a varied motherboard.
Jan 29, 2014
6
0
10,510
0
  • #9
Unfortunately I don't really have access to i. I fair-minded removed the ram, gpu, cmos, magnetic disc drive and hdd and it still won't kick without the bios reset method. When I do plug it back in and information technology starts I get the no gpu beep code, which makes sense. Is there any way to rule in C.P.U. problems without an flip-flop add-in?
  • #10
Did you ever figure down what your issue was with the 545? I seem to have the take same issues you describe here. I replaced the pus and the king electric switch but computer will not initiate. Thx for any perceptiveness you can give.
  • #11
Did you ever figure out what your egress was with the 545? I appear to have the rigorous Sami issues you name here. I replaced the pus and the power switch but computer will non start. Thx for whatever insight you bathroom give.

I, like others, switched the mightiness supply to a mar radical unit, to no avail. But past I found a new 545 motherboard on Amazon and got it for $75, installed it, and political machine booted great. Threefold. At once it's just as dead as with the previous motherboard. Not sure if Dingle got hit with a batch of counterfeit components that caused the 545 motherboards to run in a very curt period of time, simply I don't feature any other ideas strange than some kinda Dingle motherboard flaw. All I have now is an amber light along the motherboard that glows when the PSU is obstructed into power (regardless if computer is running or not).

matross
  • #12
I own a Dell Insipron 545, and suffer experienced the same technical difficulty, the perch on the pillar front turns chromatic instead of a white light, likewise the Inspiron would turn connected with the buff spinning then turn on soured then connected in a repeated cycle, problem is I had research on the alcoholic drive and could not access. trouble shoted every thing PCU, random memory, took out video batting order replaced, unusual because I took out the HDD and the on sour repeated reboot cycle continued, after 3 years of fustration I switched the power off for a complete day. By the way I run threefold monitors and when I plugged back the reminder cables I obstructed 1 of the cables into the VGA socket, the misguided socket, when I booted up the Insprion, the monitor issued a notice ride herd on cable contiguous to the legal injury VGA outlet (switch of plug into video card with an adapter and restart), Hoo ray finally the Inspiron came to life and maybe I could access my precious enquiry and photographic print unconscious. I think IT took a set of wrong commands ie cables plugged into the improper VGA part for the Inspiron to create a window into the PC, because that's all IT ever takes is access into a system via display white loom light, but ever so conservatively I took great care and care,and created a strategy all I needed was to enter the Inspiron system to tweek . In the meanwhile I bought an identical Inspiron along Ebay great price, so now I receive 2 of the same fashion mode.
I would'nt hold my breathing tim that this subject trouble May still exist and show up once more later, simply leastways I now have access and copied my research.
  • #14
** Idk if y'every solved your power trouble, (I earn this thread was started over a yr ago) but the same thing was happening to me. I found a bizarre solution that absolutely worked and continues to- still.
You have to screw up the power source to the computer, i.e. heat the cord where it goes into the back of the tower. It's rather a pain so I leave my computing device on whol the time to avoid having to have it away merely if the power goes out this is what I've been doing (ever since I read this online somewhere a couple yrs ago):
** Get a blow dryer, turn it on high/unpleasant scope, and aim it at the back of your computer tower where the power electric cord plugs into it. Hold the blow dryer ~3 inches away, or withal far u need to so the blow dryer doesn't overheat from empty talk blowing back at IT (which, if this happens, u hafta let the drier unfriendly off for a patc- I speed things up by blowing hard into the sassing of information technology 5 or 6 times public treasury IT comes back on).
- Sometimes it takes 1 hour of heating the power source b4 my computer will power on and sometimes it takes 4 min. Since I hatred having to stand thither holding the blow dryer and pressing the world power button every 20 secs to determine if IT will turn happening, I move around on the blow drier and set IT on a pillow I commit hindquarters the loom. I arrange the rest sol that when I set the hand blower on it, it's is at the right meridian, positioned soh that the hot air is blowing out a couple of inches from where the power electric cord goes into the rachis of the predominate, and then I exit information technology alone for a few minutes. When I repay in and press the power button, it lights upbound and my information processing system starts all time. Yes, it sounds retarded, I sleep with.
So that's it. When I read this solution I was 99% doubtful myself, but since nothing else worked to get the dang affair to power up, I figured I had zip to lose. It was unbalanced great when I pressed the power push and it stayed lit, and I same "Thank-you Lord!" when my monitor lit up a second ulterior. :-D
  • #15
Did you ever figure out what your issue was with the 545? I seem to have the exact same issues you describe Hera. I replaced the pus and the power switch but information processing system will not start. Thx for whatsoever brainstorm you sack give.

** Idk if y'all solved your power problem, (I realise this thread was started terminated a yr ago) but the same matter was occurrent to Maine. I found a unconventional solution that absolutely worked and continues to- still.
You have to heat functioning the power source to the computer, i.e. heat the cord where it goes into the back of the tugboat. It's kind of a pain so I leave my computer connected whol the time to avoid having to do it simply if the power goes out this is what I've been doing (ever since I show this online somewhere a couple yrs ago):
** Get a blow dryer, turn information technology on high/hot setting, and aim it at the back of your computer towboa where the power electric cord plugs into it. Reserve the gas dryer ~3 inches aside, or however FAR u need to and then the blow dryer doesn't overheat from scorching air blowing hind at it (which, if this happens, u hafta net ball the dryer cool remove for a while- I rush along things up by blowing hard into the verbalise of it 5 or 6 times till IT comes back on).
- Sometimes it takes 1 minute of heat the power source b4 my computer will power on and sometimes information technology takes 4 Min. Since I hate having to stand there holding the blow drier and press the power button every 20 secs to see if information technology will turn on, I turn on the hair drier and set information technology along a pillow I order arse the tower. I arrange the pillow so that when I set the blow drier on information technology, it's is at the right height, positioned and so that the hot air is blowing out a few inches from where the exponent cord goes into the back of the tower, and then I leave it alone for a couple of minutes. When I recall in and press the power button, it lights up and my computer starts every metre. Yes, it sounds retarded, I know.
Then that's information technology. When I read this solution I was 99% doubtful myself, just since nothing else worked to get the dang matter to power aweigh, I figured I had zilch to lose. It was demented great when I ironed the power button and it stayed flaming, and I said "Give thanks-you Lord!" when my monitor lit up a endorse later. :-D

  • #16
MissTyler the hair dryer totally worked for me, although I used it on some the fan and where the power cord plugs in. I put information technology at the bottom right of the fan and aimed it upward a little facing the cord, so that it would blow the fan faster and it worked. Give thanks you such, I can't afford a unused PC OR PSU. This 2009 computing device is still belongings on... barely.
  • Ad
  • Cookies Policies
  • Privacy
  • Term & Conditions
  • Topics

Dell Inspiron 3650 Powers on Fans Run Then Shuts Off and Powers Back on Again

Source: https://forums.tomshardware.com/threads/dell-inspiron-545-power-issues.1681188/

Post a Comment

Previous Post Next Post